HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 57)

• bonding – This parameter defines network bonding modes. <mode> is 1, 4, or 6. See the HP

StoreOnce Backup System Installation and Configuration guide for more detailed information

on supported bonding modes and related templates.

Default Bonding Mode for:DescriptionBonding mode

Templates 1, 3, 4, and 5Simple bonding mode that allows network traffic via one active

port only. If the active network fails then traffic moves to the backup

port.

Mode 1

(Active/Backup)

noneLACP bonding mode that requires a special external switch

configuration. Provides a link aggregation solution which increases

the bond physical bandwidth.

Mode 4 (IEEE

802.3ad

Dynamic Link

Aggregation)

Template 2Load balance solution that can be used in a 2–switch

configuration. The switch must allow ARP negotiation (but no

specific external switch configuration is required).

Mode 6 (Active

Load Balancing)

• ports – This parameter defines the ports which will be attached to the subnet for each node

associated with the network configuration containing the subnet. (See the “net activate config”

(page 55) command for details on how the nodes are associated with network configurations.)

The values consist of a list of integers separated by commas; the integers define the physical

ports on the nodes. Execute the “net show ports” (page 78) command to obtain information

on which integers may be used to define ports for the subnet configuration. The list may consist

of one integer value or multiple values. The maximum number of values depends on your

system; use the Command Authority (page 56) command for information on which ports are

available.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• All object values must be valid; see the object descriptions for details.

• All parameter values must be valid; see the parameter descriptions for details.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Examples

# net add subnet save1 subnet new ipaddr 1.2.3.4 gateway 5.6.7.8 netmask

255.255.0.0 domain gbr.hp.com default yes bonding 5 port eth0,eth2

net add subnet 57

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 177 178

Komentarze do niniejszej Instrukcji

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 57

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery HP D2D2502i