HP 7000 dl Router Series Podręcznik Użytkownika Pobierz pdf (Strona 599)

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

bandwidth <value>

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Enter bandwidth in kbps.

Default Values

To view default values use the show interfaces command.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), Frame Relay virtual sub-interface

(fr 1.20), virtual PPP (ppp 1), and loopback interfaces.

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the Frame Relay interface to 10 Mbps:

(config)#interface frame-relay 1.7

(config-fr 1.7)#bandwidth 10000

HP 7000 dl Router Series Podręcznik Użytkownika Strona 599