HP 7000 dl Router Series Podręcznik Użytkownika Pobierz pdf (Strona 847)

100

101

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set

LOOPBACK INTERFACE CONFIGURATION COMMAND SET

To activate the Loopback Interface Configuration , enter the interface loopback command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface loopback 1

Router(config-loop 1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 848

bandwidth <value> on page 851

crypto map <mapname> on page 852

dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on

page 855

ip commands begin on page 857

mtu <size> on page 873

snmp trap on page 874

snmp trap link-status on page 875

1 2 ... 842 843 844 845 846 847 848 849 850 851 852 ... 940 941

Komentarze do niniejszej Instrukcji

Brak uwag

HP 7000 dl Router Series Podręcznik Użytkownika Strona 847

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking HP 7000 dl Router Series