HP OfficeConnect Firewall Series Instrukcja Użytkownika Pobierz pdf (Strona 121)

OfficeConnect VPN Firewall User’s Manual Chapter 17. System Management

107

Figure 17.10 Logging Configuration Page

2. Specify a log identifier in the space provided. The log identifier is a

mandatory field used to identify the log messages. Please note that

the log identifier string should not contain any special characters

including space and the default value of Log Identifier is

3Com_Firewall.

3. In the System Logs field, please check the checkbox for the type of

system events to be logged. The available options are shown below:

 Firewall Log

 General Log

 ACL Log

 DoS Log

 WAN Link Status Log

 NTP Log

4. In the Syslog Configuration field, please check the Enable Remote

Syslog check box to enable the syslog function and then enter the IP

address of the Syslog server

5. In the E-mail Configuration field, please check the Enable E-mail

Logs checkbox to enable the E-mail Log function. Enter the IP

address of the Email (SMTP) server into the E-Mail Server Address

and Email address to the Sender and Receiver E-Mail Address

fields. Here is an example of Email address:

[email protected]om

6. If authentication is required, please select a corresponding

authentication method – either Plain Text or CRAM-MD5 based on

the information provided by your network administrator. And specify

the username and password into the space provided. If the

OfficeConnect Gigabit VPN Firewall needs to respond the IDENT

protocol from the SMTP Server, check the ―Respond to Identd from

SMTP Server‖ checkbox.

7. Enter a Schedule for sending the logs. From the drop-down list,

select: Never, Hourly, Daily, or Weekly. Then fill in the Day and Time

fields that correspond to your selection.

8. Click the button to save the changes.

17.11 Configuring SNMP

The SNMP agents maintain a list of variables, which are used to manage the

device. The variables are defined in the Management Information Base (MIB).

The SNMP agent defines the MIB specification format, as well as the format

used to access the information over the network. Access rights to the SNMP

agents are controlled by access strings.

Follow these steps to enable/disable the SNMP function or configure the SNMP

communities:

1. Click Administration > SNMP > Communities to enter the SNMP

Communities configuration page.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 155 156

Komentarze do niniejszej Instrukcji

Brak uwag

HP OfficeConnect Firewall Series Instrukcja Użytkownika Strona 121

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie HP OfficeConnect Firewall Series