HP OfficeConnect Firewall Series Instrukcja Użytkownika Pobierz pdf (Strona 50)

Chapter 5. Configuring LAN Settings OfficeConnect VPN Firewall User’s Manual

Force Version

Specifies the STP version to run on the device. The

possible values are:

Normal – RTSP mode only

Compatible – STP compatible mode

Per-port settings

Enable

Indicates that STP or RSTP is enabled on the port.

Edge

Indicates if Edge Port is enabled on the port. If Edge

Port is enabled for a port, the Port State is

automatically placed in the Forwarding state when the

port link is up. Edge Port optimizes the STP protocol

convergence. STP convergence takes 30 seconds and

is not dependent on the number of switches in the

network. However, an edge port that receives a BPDU

immediately loses edge port status and becomes a

normal spanning tree port.

Path Cost

Indicates the port contribution to the root path cost. The

path cost is adjusted to a higher or lower value, and is

used to forward traffic when a path is re-routed.

7.3 Configuring the Spanning Tree settings

Follow these steps to change the Spanning Tree settings.

1. Log into Configuration Manager as administrator, and then click the

Network menu.

When the submenus of Network menu displays, clicks on Spanning

Tree submenu to display the Spanning Tree Configuration page as

shown in Figure 7.1.

Figure 7.1 Spanning Tree Configuration Page

2. Enter the bridge priority value into the System Priority field. Please

see Table 7.1 for more detail description.

3. Enter the Hello Time value in the specified field. The Hello Time

indicates the amount of time in seconds a Root Bridge waits between

configuration messages.

4. Enter the Max Age Time value in the specified field. Please note that

the default value is 20 seconds.

5. Enter the Forward Delay Time value in the specified field. Please

note that the default value if 15 seconds.

6. Select an appropriate STP version from the Force Version drop-

down list.

7. Go to the RSTP Configuration List. Click on the Enable button to

enable the Spanning Tree function on the specified port. If this port is

also an edge port, click on the Edge button.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 155 156

Komentarze do niniejszej Instrukcji

Brak uwag

HP OfficeConnect Firewall Series Instrukcja Użytkownika Strona 50

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie HP OfficeConnect Firewall Series