HP Web Jetadmin Software Instrukcja Użytkownika Pobierz pdf (Strona 145)

TIP: At this time, the Refresh Selection (Full) feature is restricted to a single device for performance reasons. To

get the desired result, a full discovery should be done on your network or maybe only on a specic list of IP

addresses using the Specied addresses discovery option.

Find More Devices

On the All Devices page (select All Devices from the left navigation menu) in the upper right corner is a Start

discovery button. When you click that button, the Device Discovery wizard starts to walk you through the steps

needed for a successful device discovery.

You will want to use this feature after you initially install HP Web Jetadmin and then afterwards to nd additional

devices. When you rst install HP Web Jetadmin, no discovery has been run which means the All Devices list will

be empty.

Add Credentials for Devices

Some devices use credentials, which must be entered into HP Web Jetadmin for a user to access that device. If

the credentials entered by the user (when trying to access a device) do not match the credentials entered

HP Web Jetadmin, the device denies access.

The All Devices list has a Credentials Required column that shows which devices need credentials. Yes in this

column indicates that the corresponding device requires credentials; No indicates that it does not need

credentials. If a device requires credentials, you must add them before users access that device. The Needed

Credentials wizard will walk you through the steps to add credentials. The pages displayed by the wizard will

vary based on the specic credentials required by the device or devices.

To add credentials for devices, perform the following steps:

1. In the All Devices list, highlight the device or devices requiring credentials (those with a Yes in the

Credentials Required column).

2. Right-click and select Update Credentials.

3. Use the Needed Credentials wizard to enter the credential information for the device or devices. Depending

upon the credentials required by the device or devices, one or more of the following pages will be displayed

for you to complete:

TIP: Throughout the Needed Credentials wizard there is a Skip button that can be used to not enter

credentials for devices if, for example, you are unsure of the required value for the device.

●

Enter SNMPv1 Get Community Name page: Select the device for the credential, supply the Get

Community Name (can be up to 256 characters), and click Set. Then click Finish, or click Next and

follow instructions in the wizard.

●

Enter SNMPv1 Set Community Name page: Select the device for the credential, supply the Set

Community Name (can be up to 256 characters), and click Set. Then click Finish, or click Next and

follow instructions in the wizard.

●

Enter EWS or Domain Password page: Select the device for the password, type the username and

password, and click Set. Then click Finish, or click Next and follow instructions in the wizard.

●

Enter SNMPv3 Credential page: Select the device for the password and type the username, the

authenticated password, and the private password. Click Set and then click Finish.

NOTE: Enter either the EWS credentials or the Domain credentials. Enter Domain credentials as:

FullyQualifiedDomainName\Username

ENWW Device Lists 119

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 491 492

Komentarze do niniejszej Instrukcji

Brak uwag

HP Web Jetadmin Software Instrukcja Użytkownika Strona 145

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia wielofunkcyjne HP Web Jetadmin Software