HP Web Jetadmin Software Instrukcja Użytkownika Pobierz pdf (Strona 405)

Fax Billing Code

This option lets you specify the billing code information for the digital send device. Billing codes provide a way to

track faxes from dierent locations. When supported by the fax method, billing codes can be used to track the

fax source to a specic machine or sender.

Use the following steps to congure this option:

1. To allow the user to enter a billing code other than the default, select Yes from Editable by the user.

2. Type the default billing code value in Default billing code.

3. Select the minimum number of characters that a user is allowed to enter as a valid billing code from

Minimum length. (The maximum number of characters allowed for a billing code is 16.)

Fax Forwarding

Use this option to send a copy of all incoming and outgoing faxes to another fax number.

Use the following steps to congure this option:

1. To congure this option, select Enable Fax Forwarding.

2. Select the type of fax job to forward.

3. Type the fax phone number for all copies of incoming and outgoing faxes to be forwarded to.

Fax General

This option lets you specify advanced fax settings for the digital send device. You can specify the modem and

ringer volumes, whether the header information is overlaid on top of the fax image, and whether the fax device

should use JBIG compression or Error Correction Mode (ECM). Printing the header over the top of the fax image

instead of above it reduces the chance that each faxed page is larger than the selected paper size and prints as

two pages on the receiving fax device.

JBIG compression is a protocol that allows for faster fax sending between two JBIG compliant fax devices. It is

possible that older fax machines may fail to connect when JBIG is enabled. Error Correction Mode (ECM) should

normally be enabled, except in extreme circumstances where line conditions are too poor to support ECM faxes.

Use the following steps to congure this option:

1. Select the fax modem volume from Modem volume.

2. Select the fax ringer volume from the Ringer volume.

3. The phone number, time, and date are stamped at the top of all outgoing faxes. To print this information

over a small portion of the top of the fax image, select the Overlay header.

4. To disable JBIG compression, select the Disable JBIG compression.

5. To disable Error Correction Mode, select the Disable error correction.

Fax Header

You can specify the company name and fax number to be included at the top of your faxes.

Use the following steps to congure this option:

ENWW Device Conguration Options for Fax 379

1 2 ... 400 401 402 403 404 405 406 407 408 409 410 ... 491 492

Brak uwag

HP Web Jetadmin Software Instrukcja Użytkownika Strona 405