HP Web Jetadmin Software Instrukcja Użytkownika Pobierz pdf (Strona 88)

specied polling interval expires, and then waits until the specied number of devices per poll is

satised before sending new device requests.

3. Click the Apply button.

To reset all of the values to the defaults, click the Reset to Default Values button.

Congure the Polling Options for Device Tabs

Device Tab polling polls device information needed to drive the device-related information on the selected device

tabs across all clients.

Use the following steps:

1. On the top menu bar, access Tools > Options > Device Management > Device Polling > Device Tabs.

2. Congure the desired settings:

●

Polling interval: Specify the number of seconds during which HP Web Jetadmin sends device requests

to the network. The default is 5.

●

Time between polling intervals: Specify the number of seconds that HP Web Jetadmin remains idle

between polling intervals. The default is 2.

●

Number of devices per poll: Specify the number of devices that HP Web Jetadmin can query

concurrently. The default is 3.

HP Web Jetadmin sends device requests for the specied number of devices to the network in a poll

burst and waits for the responses. When HP Web Jetadmin receives the response packets, it sends

another burst of device requests. HP Web Jetadmin continues to send device requests until the

specied polling interval expires, and then waits until the specied number of devices per poll is

satised before sending new device requests.

3. Click the Apply button.

To reset all of the values to the defaults, click the Reset to Default Values button.

Congure the Polling Options for Device Alerts and Supplies Alerts

You can dene how often devices should be checked to see if they warrant alerts. Frequent polling can increase

network trac; infrequent polling might cause some device alerts to go unnoticed and, therefore, unattended.

You can also specify how long an alert event stays in the alert history log, or you can clear the alerts log at any

time.

You can congure static polling rates for supplies alerts subscriptions. This feature helps prevent missing alerts

by keeping supplies alerts subscriptions in a static polling interval. If you enable this feature, supplies alerts

subscriptions that exceed the specied threshold are placed in static polling. These supplies alerts subscriptions

remain in static polling until you disable static polling or replenish the supplies. Supplies alerts subscriptions

move to the static poller on the next polling cycle of the poller the subscription is in. If you disable this feature,

qualifying supplies alerts subscriptions move from the static poller to the most appropriate poller, which is

determined by the rate of use for the supply, on the next polling cycle of the poller the subscription is in.

Use the following steps:

1. On the top menu bar, access Tools > Options > Device Management > Device Polling > Alerts.

2. To congure polling for devices, specify the following settings:

62 Chapter 2 Introduction to HP Web Jetadmin ENWW

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 491 492

Brak uwag

HP Web Jetadmin Software Instrukcja Użytkownika Strona 88