HP Web Jetadmin Software Instrukcja Użytkownika Strona 364

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 363
CAUTION: Conguring the Sleep Timer Settings conguration option for some devices might cause those
devices to enter a deep sleep mode. USB-based solutions that are connected to these devices might be disabled.
HP Web Jetadmin does not display a message or provide any indication that the USB-based solutions will be
disabled.
To enable the Sleep Mode/Auto O feature, perform the following steps:
1. Select the Enable Sleep Mode/Auto O Timer checkbox.
2. Enter the number of minutes the device waits with no activity before entering Sleep mode in the Sleep
Mode/Auto o after eld. Valid values are 1 through 120.
3. To specify which events wake up the device, select one of the following options:
All events: The device wakes up when any event occurs.
Network port: The device wakes up only when a network port event occurs.
Power button only: The device wakes up only when the power button on the device is pressed.
To disable the Sleep Mode/Auto O feature, clear the Enable Sleep Mode/Auto O Timer checkbox.
Stacker Staple Setting
Use this option to specify the number of staples put on each print job. The stacker staple setting specied in
HP Web Jetadmin overrides the setting
specied through the printer control panel.
To congure this option, select No Stapling or One Staple
.
Stand by Fuser Mode
Use this option to set the temperature for a Fuser Mode when it is in standby mode. Turning this o means using
less energy but w
arm up time for a print job will take longer.
To set this option, select the temperature from the drop-down box.
Stapler Oset Mode
If an HP 3-bin Stapler/Stacker accessory is installed on the device, use this option to specify whether each print
job is oset in the output bin. Osetting the print jobs makes it easier to separate multiple print jobs.
To disable this option, select the O option.
To enable this option, select the On option.
Staples Out Override
Use this option to specify the default action that the printer takes when the output bin is full or when the stapler
runs out of s
taples.
To congure this option, select Stop or Continue
.
338 Chapter 6 Device Conguration Options ENWW
Przeglądanie stron 363
1 2 ... 359 360 361 362 363 364 365 366 367 368 369 ... 491 492

Komentarze do niniejszej Instrukcji

Brak uwag