HP Web Jetadmin Software Instrukcja Użytkownika Pobierz pdf (Strona 54)

j. Click the Next button.

k. On the Conrm page, verify that the information is correct, and then click the Apply Template button.

l. On the Results page, click the Done button.

m. Repeat steps b through l for each of the alert subscriptions that were created without using an alert

subscription template.

5. On the client machines where the HP Web Jetadmin client is launched, use the following steps to enable

the TLS protocol:

a. Open an Internet Explorer browser.

b. Go to Tools > Internet options, and then click the Advanced tab.

c. Scroll down to the Security section, and then select the checkboxes for one or more of the TLS

versions (TLS 1.0, TLS 1.1, and TLS 1.2).

6. Use the following steps to verify that the devices are congured to communicate with the TLS protocol:

a. Select the device from any device list.

b. On the Cong tab, go to Network > Mgmt Protocol.

c. Verify that any version of TLS (TLS 1.0, TLS 1.1, and TLS 1.2) is enabled.

d. Repeat steps a through c for each device.

7. Use the following steps to enable FIPS-140 mode on the devices. Enabling FIPS-140 mode aects only the

following device conguration options:

●

SNMP Version Access Control conguration option: The SHA-1 authentication protocol and AES-128

privacy protocol must be congured.

●

Mgmt Protocol conguration option: The TLS 1.0, TLS 1.1, or TLS 1.2 protocol must be enabled.

TIP: The following steps are not required. However, you can use these steps to troubleshoot any FIPS-

related problems.

a. Select the device from any device list.

b. On the Cong tab, go to Security > FIPS-140 Mode.

c. Select the Enabled option.

d. Click the Apply button.

e. Repeat steps a through d for each device.

If any of the following device conguration options are congured on a device, enabling FIPS-140 mode

fails for that device:

●

SNMP Version Access Control conguration option: The MD5 authentication and DES privacy protocols

must not be specied.

●

IPsec/Firewall Policy conguration option: The DES-CBC-MD5 algorithm must not be specied for the

Kerberos setting.

●

Upload Jetdirect Certicate conguration option: Certicates must not be signed by using MD5 or

earlier (MD2 or MD4).

28 Chapter 1 Install and Set Up HP Web Jetadmin ENWW

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 491 492

Brak uwag

HP Web Jetadmin Software Instrukcja Użytkownika Strona 54